How to install subway tile backsplash step by step: 1 Step 1: Start from the bottom. Begin by laying out an old towel or sheet over your countertop for protection. Starting on the bottom row at an outer 2 Step 2: Place subway tile spacers. 3 Step 3: Second subway tile backsplash row. 4 Step 4: How to cut a tile. 5 Step 5: Tile around outlets.
How to make a backsplash out of subway tiles?
Throughout a weekend or two, you can make a chic and practical backsplash out of the subway tiles of your choosing. Measure the area and purchase 10% more tile than you need. Use a tape measure and measure the width and length of the space you want to cover with subway tiles. Multiply these numbers by each other.
How do you install a backsplash on a kitchen wall?
Place spacers between the tiles. Tip: Place two spacers per side of tile, about ½” to 1” away from each corner of the tile. Before you move on to the third tile, check for level. Make any adjustments needed. This is a critical step, particularly for the bottom row of tiles, as it sets the foundation for the rest of the backsplash.
Before you begin tiling, check out the existing surface you’ll be working on. If you are installing a backsplash behind a sink or area with moisture, you’ll need to be sure you’re working on water-resistant drywall or a rock-based board.
How do you measure for subway tile in a bathroom?
If you’re following the traditional subway tile layout, this means that you’ll start with a half tile from the outer edge. Measure halfway down your tile and mark with a pencil. Line up your halfway mark with the middle of a manual tile snapper, shiny side up.
Test your outlets before you begin to double check that the power is off. When you begin installing your subway tile, it can be really tempting to allow the first row of tiles to sit directly on the countertop. Avoid doing this.
How many spacers do I need for a backsplash?
Tip: Place two spacers per side of tile, about ½” to 1” away from each corner of the tile. Before you move on to the third tile, check for level. Make any adjustments needed. This is a critical step, particularly for the bottom row of tiles, as it sets the foundation for the rest of the backsplash.